8 - 25
Chapter 8 Printer Specifications
10. Options
10.1 Factory Options
♦ 34PPM
The three options which are factory-installed according to the specifications are as follows:
• Toner Sensor function
This is a function of detecting that the toner level in the EP CARTRIDGE is low, using SENSOR
TONER.
• Low Paper Sensor function
This is a function of detecting that the paper in the paper cassette is low, using SENSOR LOW
PAPER.
• EP CARTRIDGE with peeling fingers
♦ 24PPM
The five options which are factory-installed according to the specifications are as follows:
• Toner Sensor function
This is a function of detecting that the toner level in the EP CARTRIDGE is low, using SENSOR
TONER.
• Low Paper Sensor function
This is a function of detecting that the paper in the paper cassette is low, using SENSOR LOW
PAPER.
• EP CARTRIDGE with peeling fingers
• 1200dpi
• 500 Paper Exit
10.2 User-Installed Options
The four options that the user can install are as follows:
♦ Option 550 Paper Feeder (with Option 550 Paper Cassette)
This is the same as the paper tray installed in the machine body. This can hold about 550 sheets
of standard paper.
♦ Option Duplex
This is a transport mechanism that can be added on to the machine to perform duplex printing by
inverting the paper.
♦ Option OCT
This is a paper output unit that can be added on to the machine to shift the paper output position
at every desired number of prints.
♦ Option Face Up Tray
This is a tray that is added on to the machine to receive the output paper with the printed surface
upward.
10.3 ESS Options
♦ Extension Network ROM Kit
♦ Expanded RAM module(128MB SO-DIMM)
♦ Expanded RAM module(256MB SO-DIMM)
♦ Parallel Interface Cable
♦ Serial Interface Cable
♦ USB Cable
To Previous Page
Loading...
