1 - 78
Chapter 1 Troubleshooting
FIP2.45 SENSOR FACE UP OPEN (PL10.1.25)
Step Check Yes No
Possible causative parts:
SENSOR FACE UP OPEN (PL10.1.25)
GATE FU (PL10.2.6)
LEVER GATE FU (PL10.2.17)
HARNESS ASSY EXIT SNR (PL10.1.27)
HVPS/MCU (PL12.1.19)
1
Checking GATE FU for operation
Open COVER ASSY REAR 500.
Move LEVER GATE FU up and down. Does GATE FU
operate smoothly? Does the actuator go into the sensor
detecting point when LEVER GATE FU is moved up, and
out of the detecting point when down?
With tool
Go to step 2.
Without tool
Go to step 3.
Replace LEVER
GATE FU and
GATE FU.
2
Checking SENSOR FACE UP OPEN for operation (1)
Remove EP CARTRIDGE.
Close COVER ASSY REAR 500.
Move LEVER GATE FU up and down. Does the number
increase one by one, every time LEVER GATE FU
operates?
Checks by Chapter 2 Diagnostic [Sensor/Switch Chec].
Replace
HVPS/MCU.
(RRP12.10)
Go to step 3.
3
Checking HARNESS ASSY EXIT SNR for continuity
Remove 500 EXIT ASSY (PL10.1.2) (RRP10.2)
Remove HARNESS ASSY EXIT SNR.
Are the following continuous normally?
J29-4 <=> J291-3
J29-5 <=> J291-2
J29-6 <=> J291-1
Go to step 4.
Replace
HARNESS ASSY
EXIT SNR.
4
Checking SENSOR FACE UP OPEN for operation
Replace SENSOR FACE UP OPEN. (RRP10.6)
Is the problem cleared?
End of work
Replace
HVPS/MCU.
(RRP12.10)
To Next Page
Loading...
