1 - 33
Chapter 1 Troubleshooting
FIP1.9 Paper Jam/Tray to Regi
Step
Check Yes No
Possible causative parts:
150 FEEDER ASSY (PL5.1.1)
150 PAPER CASSETTE (PL2.1.50)
SENSOR REGI (PL5.1.30)
ACTUATOR B (PL5.1.17)
CHUTE ASSY FDR1 (PL5.1.3)
HVPS/MCU (PL12.1.19)
LVPS (PL12.1.5)
CHUTE ASSY FDR2 (PL6.1.22, PL7.1.21, PL20.2.2)
CLUTCH ASSY PH (PL5.1.21, PL6.1.21, PL7.1.20,
PL20.2.21)
ROLL ASSY RETARD (PL2.1.2, PL3.1.2, PL4.1.2,
PL20.3.2)
CLUTCH PR-REGI (PL20.2.22)
550 FEEDER OPION (PL20.2.1)
250 FEEDER ASSY (PL6.1.11)
250 PAPER CASSETTE (PL3.1.50)
550 FEEDER ASSY (PL7.1.10)
550 PAPER CASSETTE (PL4.1.50)
1
Checking the paper size setup
Does the paper size in use match the size setup by GUIDE
ASSY END or by the driver on the PC?
Go to step 2.
Replace the
paper, or change
the paper size
setup.
2 Does Error occur when the power is turned ON? Go to step 3. Go to step 5.
3
Checking the paper at ACTUATOR B
Does the paper remain at ACTUATOR B of SENSOR
REGI?
Remove the
paper, and go to
step 4.
Go to FIP2.5
SENSOR REGI.
4 Does Error occur when the power is turned ON?
Go to FIP2.5
SENSOR REGI.
Go to step 5.
5
Checking ROLL ASSY RETARD
Is ROLL ASSY RETARD not damaged, and installed
correctly?
Check the operation of it assembled each Paper Cassette.
Go to step 6.
Replace ROLL
ASSY RETARD
(RRP2.1, 3.1, 4.1,
20.17)
6
Carrying out a test printing
Does Error occur, when the test printing is done with the
paper supplied from the Tray 1 or Tray 2?
With the Option 550 Paper Feeder is installed, does Error
occur, when the test printing is done with the paper
supplied from the Tray 3 or Tray 4?
Checks by Chapter 2 Diagnostic [TEST PATTERN MODE
MENU].
Go to step 7.
End of work
7
Checking the paper position
Remove EP CARTRIDGE.
Does the front end of paper touch Actuator B of SENSOR
REGI?
Go to step 8.
Go to FIP2.5
SENSOR REGI.
To Next Page
Loading...
