1 - 36
Chapter 1 Troubleshooting
Step
Check Yes No
5 Is Side Guide tightening the paper too much?
Slightly widen the
Side Guide, and
run the paper
again.
Go to step 6.
6
Checking GEAR ASSY HOUSING for rotation
Remove EP CARTRIDGE.
Does each gear of GEAR ASSY HOUSING rotate
normally?
Checks by Chapter 2 Diagnostic [Main Motor Test].
Go to step 7.
Check operation
and mounting of
GEAR ASSY
HOUSING, and
then go to FIP2.2
MAIN MOTOR.
7
Checking paper position
Remove EP CARTRIDGE.
Does the front end of paper touch ACTUATOR B of
SENSOR REGI?
Go to step 8.
Go to FIP2.5
SENSOR REGI.
8
Checking ROLL ASSY RETARD
Is ROLL ASSY RETARD clean and installed correctly?
Check ROLL ASSY RETARD installed to each Paper
Cassette.
Go to step 9.
Replace ROLL
ASSY RETARD.
(RRP2.1, 3.1, 4.1,
20.17)
9
Checking the paper feeding tray
Is the paper for test printing supplied from Tray 1 or Tray
2?
With tool
Go to step 10.
Without tool
Go to step 11.
Go to step 12.
10
Checking CLUTCH ASSY PH for operation
Does CLUTCH ASSY PH operate normally?
Checks by Chapter 2 Diagnostic [Tray1/2 Feed Clutch
Test].
Go to step 12.
Go to FIP2.16
CLUTCH ASSY
PH.
11
Checking CHUTE ASSY FDR1/2 for rotation
Does each gear and roller of CHUTE ASSY FDR1/2 rotate
smoothly?
Turn each gear and roller with a finger to check.
Go to step 12.
Replace CHUTE
ASSY FDR1/2.
12
Checking the paper feeding tray
Is the paper for test printing supplied from Tray 3 or Tray
4?
With tool
Go to step 13.
Without tool
Go to step 14.
Confirm that the
paper is set, and
then go to step 9.
13
Checking CLUTCH ASSY PH for operation
Does CLUTCH ASSY PH operate normally?
Checks by Chapter 2 Diagnostic [Option Tray1/2 Feed
Clutch Test].
Go to step 15.
Go to FIP2.25
CLUTCH ASSY
PH.
14
Checking 550 FEEDER OPTION for operation
Does each gear and roller of 550 FEEDER OPTION rotate
smoothly?
Turn each gear and roller with a finger to check.
Go to step 16.
Replace 550
FEEDER
OPTION.
(RRP20.9)
To Next Page
Loading...
