2 - 23
Chapter 2 Operation of Diagnostic
• A value in the range between 10 and 205 is shown as the entire HDD size. The unit is 0.1 Gbyte.
7. Show the partition size display screen [Partition List A 40] using the " ↓ " key. You can select the
partitions [Partition List A 40], [Partition List B 40], [Partition List C 40], [Partition List D 30],
[Partition List H 05] and [Partition List ALL 186] in that order, using the " ↓ " or " ↑ " key.
• A value in the range between 1 and 40 is shown as a partition size. The unit is 0.1 Gbyte.
8. Press the "MENU" key to return to the common menu screen [Diag. Menu Fault Diag.].
If the test has been completed abnormally, make partition size settings ("Partition
setting").
9. Press the "MENU" key to return to the common menu screen [Diag. Menu Fault Diag.].
<Setting a partition size>
"If the read verification test has been completed abnormally, make partition size
settings
("Partition setting").
Procedure:
1. Enter the Diag (C/E) mode, and select [Diag. Menu Fault Diag.] in the same hierarchical level using
the " ↓ " key.
2. Select the [Fault Diag. DC140 Monitor] screen in a lower level using the " → " key.
3. Select [Fault Diag. DC355 HDD DIAG] in the same hierarchical level using the " ↓ " key.
4. Select the [DC355 HDD DIAG Read Verify Test] screen using the " → " key.
5. Select [DC355 HDD DIAG Partition setting] in the same hierarchical level using the " ↓ " key.
6. Show the confirmation message screen [Clear HDD data If OK press SEL] using the " → " key.
7. Show the initial value screen [Partition setting A 40] for the size-adjustable partition using the
"FEED / SELECT" key. You can select the initial value screens [Partition setting A 40],
[Partition setting B 40], [Partition setting C 40], [Partition setting D 30] and [Partition setting F30] in
that order, using the " ↓ " or " ↑ " key.
8. Show the setting value change screen using the " → " key.
If you want to set a partition size without changing any initial setting, press the " ↓ "
key several times and go to the step 12.
• A value in the range between 1 and 40 is shown as a currently set partition size. The unit is 0.1
Gbyte.
• To set the partition size, move the cursor using the " ← " or " → " key and change a numerical
value using the " ↑ " or " ↓ " key.
A
4
0
To Next Page
Loading...
