2 - 29
Chapter 2 Operation of Diagnostic
If you want to execute an output without changing any setting item, press the " ↓ "
key several times until [DC612 PatternPrt If OK press SEL] is shown, and press the
"FEED / SELECT" key to execute a test pattern output.
9. Show the tray change screen using the " → " key.
10. Specify the tray to which to output paper using the " ↑ " or " ↓ " key.
11. The tray is fixed by pressing the "FEED / SELECT" key. Then, "*" is marked at the right end of the
tray field.
12. Show the execution instruction screen [DC612 PatternPrt If OK press SEL] using the " ↑ " or " ↓ "
key.
13. Execute a test pattern print using the "FEED / SELECT" key. During the execution, [DC612 Pattern-
Prt In progress] is shown.
• If you want to stop printing a test pattern, use the "CANCEL" key.
14. After the execution has been completed, the [DC612 PatternPrt If OK press SEL] screen is shown
again.
15. Press the "MENU" key to return to the common menu screen [Diag. Menu Fault Diag.].
Tray
Tray 1
To Next Page
Loading...
