2 - 34
Chapter 2 Operation of Diagnostic
2.4 DC131 NVM R/W
Reads from and writes to NVM.
Chain-
Link
Content
Size
(Reference)
Add Details
740-001
Configuration1 1 byte NV 00 bit0:
1 = LowPaperSensor is not available
0 = available
bit1:
1 = Toner Sensor is not available
0 = available
740-002
Configuration2 1 byte NV 01 bit0:
1 = US
0 = JP
bit1:
1 = Tray1 detected (Post card)
0 = A5L *(Factory-shipped)
bit2:
1 = Long (Enabled)
0 = Disabled *( Factory-shipped)
bit3:
1 = Tray1 (SSI)
0 = 150CST
740-003
Configuration3 1 byte NV 02 Reserve
740-004
Resolution 1 byte NV 03 0: 600dpi
1: 1200dpi
740-005
LD Power 1 byte NV 04 0-7: Adjustment value of Laser Diode output
(4 = initial)
740-006
Print Density 1 byte NV 05 0-15: Adjustment value of Print Density
(8 = initial)
740-007
VDO1/VDO2 time
lag
1 byte NV 06 0-15: Adjustment value of VDO1/VDO2 time lag
(6 = initial)
740-008
Adjustment
Option
1 byte NV 07 bit0:
1 = DB-AC mode 2
0 = DB-AC mode 1
740-009
Interface Option
(REG code
WRITE)
1 byte NV 08 bit0-2:Reserved
bit3:
1 = REG code WRITE enable
0 = disable (initial)
741-001
REG Process MSI 1 byte RG 00 0-15: (8 = initial)
Adjustment Value of Paper Feed Direction (MSI).
Rewritable if 740-009 Bit3 is 1.
741-002
REG Process T1 1 byte RG 01 0-15: (8 = initial)
Adjustment Value of Paper Feed Direction (Tray1).
Rewritable if 740-009 Bit3 is 1.
741-003
REG Process T2 1 byte RG 02 0-15: (8 = initial)
Adjustment Value of Paper Feed Direction (Tray2).
Rewritable if 740-009 Bit3 is 1.
741-004
REG Process T3 1 byte RG 03 0-15: (8 = initial)
Adjustment Value of Paper Feed Direction (Tray3).
Rewritable if 740-009 Bit3 is 1.
741-005
REG Process T4 1 byte RG 04 0-15: (8 = initial)
Adjustment Value of Paper Feed Direction (Tray4).
Rewritable if 740-009 Bit3 is 1.
To Next Page
Loading...
