3 – 16
Chapter 3 Removal and Replacement Procedures (RRPs)
Removal
1) Remove the COVER REAR 500/COVER REAR 250 (PL10.2.21/9.1.12). (RRP10.9/9.4)
2) Remove the COVER REAR (PL1.1.3). (RRP1.1)
3) Shift the COVER LEFT in the direction of the arrow to release the 4 hooks, two below and two on
rear, securing the COVER LEFT to the printer.
4) Shift the COVER LEFT downward to release the 3 hooks securing the top of it, and remove the
COVER LEFT from the printer.
Replacement
1) Shift the COVER LEFT upward to lock the 3 hooks to the printer.
2) Shift the COVER LEFT frontward to lock the 4 hooks, two below and two on rear, to the printer.
3) Install the COVER REAR (PL1.1.3) (RRP1.1)
There are 2 kinds of screws, make sure they are put in the right place.
4) Install the COVER REAR 500/COVER REAR 250 (PL10.2.21/9.1.12). (RRP10.9/9.4)
To Next Page
Loading...
