3 – 24
Chapter 3 Removal and Replacement Procedures (RRPs)
34PPM
Removal
1) Remove the COVER REAR 500 (PL10.2.21). (RRP10.9)
2) Remove the COVER REAR (PL1.1.3). (RRP1.1)
3) Remove the COVER LEFT (PL1.1.6). (RRP1.3)
4) Remove the COVER RIGHT (PL1.1.4). (RRP1.2)
5) Remove the COVER EXIT 500 (PL10.1.1). (RRP10.1)
6) Remove the 500 EXIT ASSY (PL10.1.2). (RRP10.2)
7) Remove the COVER TOP (PL1.1.7). (RRP1.4)
8) Release the 2 hooks of the COVER FRONT securing it to the printer by pressing down the 2 hooks
at the upper portion of it, and open it to forward.
9) Shift the COVER FRONT in the direction of the arrows. Remove the COVER FRONT from the
printer by releasing the 2 hooks at the lower portion of it.
Replacement
1) Hang the 2 hooks at the lower portion of the COVER FRONT to the printer.
2) Lock the 2 hooks at the upper portion of the COVER FRONT to the printer, and secure it to the
printer.
3) Install the COVER TOP (PL1.1.7). (RRP1.4)
4) Install the 500 EXIT ASSY (PL10.1.2). (RRP10.2)
When installing, put the harnesses of the MOTOR ASSY EXIT and HARNESS ASSY
EXIT SNR1 into the square hole of the frame.
5) Install the COVER EXIT 500 (PL10.1.1). (RRP10.1)
6) Install the COVER RIGHT (PL1.1.4). (RRP1.2)
7) Install the COVER LEFT (PL1.1.6). (RRP1.3)
8) Install the COVER REAR (PL1.1.3). (RRP1.1)
9) Install the COVER REAR 500 (PL10.2.21). (RRP10.9)
To Next Page
Loading...
