3 – 105
Chapter 3 Removal and Replacement Procedures (RRPs)
Install the lower GEAR BTM PINION after installing the upper GEAR BTM LOCK
PINION. When installing the lower GEAR BTM PINION, press RACK BTM LOCK 550
in the direction of arrow until it bumps into the edge. (NOTE3)
6) Secure the COVER BTM UP 550 (PL4.1.22) to the HOUSING BASE 550 using the screw (gold
tapping, 6mm).
7) Install the GEAR PB R (PL4.1.20) to the SHAFT PB (PL4.1.9), and secure it with the hook.
Be sure to install the hook of the GEAR PB R into the groove of the SHAFT PB.
8) Install the PLATE GEAR LOCK 550 (PL4.1.19) to the HOUSING BASE 550, and secure it with the
hook.
9) Secure the PLATE GEAR LOCK 550 using the screw (gold tapping, 8mm).
10) Push the PLATE ASSY BTM (PL4.1.10) downward to lock.
Confirm that there is no space between RACK BTM LOCK 550 and HOUSING BASE
550 when pressing the center of RACK BTM LOCK 550 against HOUSING BASE
550.
To Next Page
Loading...
