Oki B6200 - Page 290

3 – 126
Chapter 3 Removal and Replacement Procedures (RRPs)
Removal
1) Open the COVER OPEN (PL1.1.2).
2) Remove the ROLL ASSY FEED (PL5.1.44). (RRP5.2)
When removing, do not hold the rubber rollers of the ROLL ASSY FEED.
3) Pull out the CLUTCH ONEWAY FEED (PL5.1.43) from the SHAFT FEED (PL5.1.41).
4) Remove the E-ring securing the CLUTCH ONEWAY NUDGER (PL5.1.42) to the SHAFT FEED.
5) Pull out the CLUTCH ONEWAY NUDGER from the SHAFT FEED.
Replacement
1) Install the CLUTCH ONEWAY NUDGER (PL5.1.42) to the SHAFT FEED (PL5.1.41).
2) Clip the E-ring to the SHAFT FEED to secure the CLUTCH ONEWAY NUDGER.
3) Install the CLUTCH ONEWAY FEED (PL5.1.43) to the SHAFT FEED.
4) Install the ROLL ASSY FEED (PL5.1.44) to the SHAFT FEED, and secure it with the hook.
(RRP5.2)
Be sure to install the hook of the ROLL ASSY FEED into the groove of the SHAFT
FEED.
5) Close the COVER OPEN (PL1.1.2).