Oki B6200 - Page 325

3 – 161
Chapter 3 Removal and Replacement Procedures (RRPs)
Removal
1) Remove the COVER REAR 250 (PL9.1.12). (RRP9.4)
2) Remove the FUSER ASSY (PL8.1.20). (RRP8.8)
3) Remove the COVER REAR (PL1.1.3). (RRP1.1)
4) Remove the FAN MAIN (PL12.1.10). (RRP12.6)
5) Remove the CHUTE TRANSFER (PL8.1.22) together with the BTP ASSY. (RRP8.11)
6) Remove the 150 FEEDER ASSY (PL5.1.1). (RRP5.1)
7) Remove the screw (gold, 6mm) securing the HOLDER NO PAPER SENSOR (PL6.1.37).
8) Remove the HOLDER NO PAPER SENSOR from the 250 FEEDER ASSY.
9) Release the hooks securing the SENSOR NO PAPER to the HOLDER NO PAPER SENSOR, and
remove the SENSOR NO PAPER.
10) Disconnect the HARNESS ASSY TRAY 2 (PL6.1.36) from the connector (P/J246) of the SENSOR
NO PAPER.
Replacement
1) Connect the connector (P/J246) of the HARNESS ASSY TRAY 2 (PL6.1.36) to the connector of
the SENSOR NO PAPER.
2) Install the SENSOR NO PAPER to the HOLDER NO PAPER SENSOR (PL6.1.37), and secure it
using hooks.
3) Put the wires of the HARNESS ASSY TRAY 2 into the notch of the HOLDER NO PAPER SENSOR
as shown in the figure.
4) Install the HOLDER NO PAPER SENSOR to the 250 FEEDER ASSY using the screw (gold, 6mm).
After tightening the screw, make sure that the wires of the HARNESS ASSY TRAY 2
have not pinched.
5) Install the 150 FEEDER ASSY (PL5.1.1). (RRP5.1)
6) Install the CHUTE TRANSFER (PL8.1.22) together with the BTR ASSY. (RRP8.11)
Do not tighten the screw to the left side hole of the CHUTE TRANSFER.
7) Install the FAN MAIN (PL12.1.10). (RRP12.6)
8) Install the COVER REAR (PL1.1.3). (RRP1.1)
There are 2 kinds of screws, make sure they are put in the right place.
9) Install the FUSER ASSY (PL8.1.20). (RRP8.8)
10) Install the COVER REAR 250 (PL9.1.12). (RRP9.4)