Oki B6200 - Page 344

3 – 180
Chapter 3 Removal and Replacement Procedures (RRPs)
Removal
1) Open the COVER OPEN (PL1.1.2) so that the removing operation can be checked visually.
2) Remove the Paper Cassettes of the Tray 1 and Tray 2.
3) Lift up the 150 FEEDER ASSY (PL5.1.1).
Althrough the 150 FEEDER ASSY clicks into midway when lifted up, push it a little
bit further.
4) While holding the 150 FEEDER ASSY, remove the ROLL ASSY FEED (PL7.1.29) b y hand which
is inserted through the space left by the Paper Cassettes. (RRP7.2)
When removing, do not hold the rubber rollers of the ROLL ASSY FEED.
5) Pull out the CLUTCH ONEWAY FEED (PL76.1.28) from the SHAFT FEED (PL7.1.26).
6) Remove the E-ring securing the CLUTCH ONEWAY NUDGER to the SHAFT FEED.
7) Pull out the CLUTCH ONEWAY NUDGER from the SHAFT FEED.
Replacement
1) Install the CLUTCH ONEWAY NUDGER to the SHAFT FEED (PL7.1.26), and secure it using the
E-ring.
2) Install the CLUTCH ONEWAY FEED (PL7.1.28) to the SHAFT FEED.
3) Install the ROLL ASSY FEED (PL7.1.29) to the SHAFT FEED, and secure it with the hook.
(RRP7.2)
Be sure to install the hook of the ROLL ASSY FEED into the groove of the SHAFT
FEED.
When installing, do not hold the rubber rollers of the ROLL ASSY FEED.
4) Press the 150 FEEDER ASSY (PL5.1.1) down so that it returns to the original position.
5) Close the COVER OPEN (PL1.1.2).