Oki B6200 - Page 355

3 – 191
Chapter 3 Removal and Replacement Procedures (RRPs)
Removal
1) Rewmove the EP CARTRIDGE and Paper Cassettes.
2) Remove the COVER REAR 500/COVER REAR 250 (PL10.2.21/9.1.12). (RRP10.9/9.4)
3) Remove the COVER REAR (PL1.1.3). (RRP1.1)
4) Remove the FUSER ASSY (PL8.1.20). (RRP8.8)
5) Remove the COVER LEFT (PL1.1.6). (RRP1.3)
6) Remove the COVER RIGHT (PL1.1.4). (RRP1.2)
7) Remove the COVER EXIT 500/CHUTE ASSY EXIT 250 (Reference Only) (PL10.1.1/9.1.14).
(RRP10.1/9.7)
8) Remove the 500 EXIT ASSY/CHUTE LW EXIT EXT2 ASSY (PL10.1.2/9.1.2). (RRP10.2/9.1)
9) Remove the COVER TOP (PL1.1.7). (RRP1.4)
10) Remove the COVER FRONT (PL1.1.5). (RRP1.5)
11) Place the printer down on its right side.
12) Disconnect the connector (P/J260) of the HARNESS ASSY LOW PAPER SNR from the GUIDE
TRAY RIGHT.
13) Remove the screw (silver, 6mm) securing the GUIDE TRAY RIGHT to the frame.
14) Lift up the hook of the GUIDE TRAY RIGHT, and shift it in the direction of the arrow. Then, remove
the GUIDE TRAY RIGHT from the frame.
Replacement
1) Shift the GUIDE TRAY RIGHT in the opposite direction of the arrow to install it to the frame, and
secure it using the screw (silver, 6mm).
When installing the GUIDE TRAY RIGHT, make sure the installing position of the
PLATE CST LOCK (PL7.1.6) is in the position shown in the figure, NOTE.
2) Connect the connector (P/J260) of the HARNESS ASSY LOW PAPER SNR to the GUIDE TRAY
RIGHT.
3) Return the printer to the normal use state.
4) Install the COVER FRONT (PL1.1.5). (RRP1.5)
5) Install the COVER TOP (PL1.1.7). (RRP1.4)
6) Install the 500 EXIT ASSY/CHUTE LW EXIT EXT2 ASSY (PL10.1.2/9.1.2). (RRP10.2/9.1)
7) Install the COVER EXIT 500/CHUTE ASSY EXIT 250 (Reference Only) (PL10.1.1/9.1.14).
(RRP10.1/9.7)
8) Install the COVER RIGHT (PL1.1.4). (RRP1.2)
9) Install the COVER LEFT (PL1.1.6). (RRP1.3)
10) Install the FUSER ASSY (PL8.1.20). (RRP8.8)
11) Install the COVER REAR (PL1.1.3). (RRP1.1)
There are 2 kinds of screws, make sure they are put in the right place.
12) Install the COVER REAR 500/COVER REAR 250 (PL10.2.21/9.1.12). (RRP10.9/9.4)
13) Install the EP CARTRIDGE and Paper Cassettes.