Oki B6200 - Page 374

3 – 210
Chapter 3 Removal and Replacement Procedures (RRPs)
34PPM
Removal
1) Remove the COVER REAR 500 (PL10.2.21). (RRP10.9)
2) Remove the COVER REAR (PL1.1.3). (RRP1.1)
3) Remove the COVER LEFT (PL1.1.6). (RRP1.3)
4) Remove the COVER RIGHT (PL1.1.4). (RRP1.2)
5) Remove the COVER EXIT 500 (PL10.1.1). (RRP10.1)
6) Remove the 500 EXIT ASSY (PL10.1.2) (RRP10.2)
7) Remove the COVER TOP (PL1.1.7). (RRP1.4)
8) Remove the COVER FRONT (PL1.1.5). (RRP1.5)
9) Remove the DUCT FRONT (PL8.1.4). (RRP8.2)
10) Remove the FUSER ASSY (PL8.1.20). (RRP8.8)
11) Remove the ROS ASSY (PL8.1.1). (RRP8.1)
Never give any impact to the ROS ASSY with a screwdriver or other tools.
12) Remove the 2 screws (black with flange, 8mm) securing the SHIELD PLATE ROS to the frame.
13) Move the SHIELD PLATE ROS in the direction of the arrows to remove.
Replacement
1) Install the SHIELD PLATE ROS by moving it in the opposite direction of the arrows.
2) Secure the SHIELD PLATE ROS using the 2 screws (black with flange, 8mm) to the flame.
Never give any impact to the ROS ASSY with a screwdriver or other tools.
3) Install the FUSER ASSY (PL8.1.20). (RRP8.8)
4) Install the DUCT FRONT (PL8.1.4). (RRP8.2)
5) Install the COVER FRONT (PL1.1.5). (RRP1.5)
6) Install the COVER TOP (PL1.1.7). (RRP1.4)
7) Install the 500 EXIT ASSY (PL10.1.2). (RRP10.2)
8) Install the COVER EXIT 500 (PL10.1.1). (RRP10.1)
9) Install the COVER RIGHT (PL1.1.4). (RRP1.2)
10) Install the COVER LEFT (PL1.1.6). (RRP1.3)
11) Install the COVER REAR (PL1.1.3). (RRP1.1)
There are 2 kinds of screws, make sure they are put in the right place.
12) Install the COVER REAR 500 (PL10.2.21). (RRP10.9)