Oki B6200 - Page 429

3 – 265
Chapter 3 Removal and Replacement Procedures (RRPs)
Removal
1) Remove the COVER REAR 250 (PL9.1.12). (RRP9.4)
2) Remove the COVER REAR (PL1.1.3). (RRP1.1)
3) Remove the COVER LEFT (PL1.1.6). (RRP1.3)
4) Remove the CHUTE ASSY EXIT 250 (Reference Only) (PL9.1.14). (RRP9.7)
5) Remove the CHUTE LW EXT2 ASSY (PL9.1.2). (RRP9.1)
6) Remove the 2 screws (gold tapping, 8mm) securing the BRACKET MOTOR (PL9.1.10) to the
CHUTE LOW EXIT 250 (PL9.1.5).
7) Remove the BRACKET MOTOR together with the MOTOR ASSY EXIT.
8) Remove the GEAR 17 and GEAR 16/49 from the CHUTE LOW EXIT 250.
Replacement
1) Install the GEAR 17 and GEAR 16/49.
When installing, install the GEAR 17 in the direction shown in the figure.
2) Install the BRACKET MOTOR (PL9.1.10) to the CHUTE LOW EXIT 250 (PL9.1.5) using the 2
screws (gold tapping, 8mm).
3) Install the CHUTE LW EXT2 ASSY (PL9.1.2). (RRP9.1)
4) Install the CHUTE ASSY EXIT 250 (Reference Only) (PL9.1.14). (RRP9.7)
5) Install the COVER LEFT (PL1.1.6). (RRP1.3)
6) Install the COVER REAR (PL1.1.3). (RRP1.1)
There are 2 kinds of screws, make sure they are put in the right place.
7) Install the COVER REAR 250 (PL9.1.12). (RRP9.4)