3 – 267
Chapter 3 Removal and Replacement Procedures (RRPs)
Removal
1) Open the COVER REAR 250.
2) Move the STOPPER FSR in the direction of the arrow to remove.
3) Release the hook of the boss on the COVER REAR 250, and shift the COVER REAR 250 in the
direction of the arrow to remove from the printer.
Replacement
1) Shift the COVER REAR 250 in the opposite direction of the arrow to install, and secure it with the
hook.
2) Insert the A portion of the STOPPER FSR into the COVER REAR 250 first, and insert the opposite
side of the A portion .
3) Close the COVER REAR 250.
To Next Page
Loading...
