3 – 273
Chapter 3 Removal and Replacement Procedures (RRPs)
Removal
1) Open the COVER REAR 250 (PL9.1.12).
2) Remove the 2 screws (silver with flange, 8mm) securing the CHUTE ASSY EXIT 250 (Reference
Only) to the printer.
3) Remove the CHUTE ASSY EXIT 250.
Replacement
1) Put 2 hooks of the front side of the CHUTE ASSY EXIT 250 (Reference Only) into the holes of the
printer.
2) Install the CHUTE ASSY EXIT 250 to the printer.
When installing, pull the levert of the CHUTE EXIT FUSER .
3) Secure the CHUTE ASSY EXIT 250 to the printer using the 2 screws (silver with falnge, 8mm).
4) Close the COVER REAR 250 (PL9.1.12).
To Next Page
Loading...
