Oki B6200 - Page 447

3 – 283
Chapter 3 Removal and Replacement Procedures (RRPs)
Removal
1) Remove the COVER REAR 500 (PL10.2.21). (RRP10.9)
2) Remove the COVER REAR (PL1.1.3). (RRP1.1)
3) Remove the COVER LEFT (PL1.1.6). (RRP1.3)
4) Remove the COVER RIGHT (PL1.1.4). (RRP1.2)
5) Remove the COVER EXIT 500 (PL10.1.1). (RRP10.1)
6) Remove the 500 EXIT ASSY (PL10.1.2). (RRP10.2)
7) Remove the CHUTE LOW EXIT (PL10.1.21). (RRP10.3)
8) Remove the 2 screws (silver, 6mm) securing the MOTOR ASSY EXIT to the BRACKET MOTOR
EXIT (PL10.1.16).
9) Remove the MOTOR ASSY EXIT.
Replacement
1) Secure the MOTOR ASSY EXIT to the BRACKET MOTOR EXIT (PL10.1.16) using the 2 screws
(silver, 8mm).
2) Install the CHUTE LOW EXIT (PL10.1.21). (RRP10.3)
3) Install the 500 EXIT ASSY (PL10.1.2). (RRP10.2)
4) Install the COVER EXIT 500 (PL10.1.1). (RRP10.1)
5) Install the COVER RIGHT (PL1.1.4). (RRP1.2)
6) Install the COVER LEFT (PL1.1.6). (RRP1.3)
7) Install the COVER REAR (PL1.1.3). (RRP1.1)
There are 2 kinds of screws, make sure they are put in the right place.
8) Install the COVER REAR 500 (PL10.2.21). (RRP10.9)