Oki B6200 - Page 461

3 – 297
Chapter 3 Removal and Replacement Procedures (RRPs)
Removal
1) Remove the COVER REAR 500 (PL10.2.21). (RRP10.9)
2) Remove the 5 screws (gold tapping, 6mm) securing the CHUTE LOW FU (PL10.2.7) to the
COVER REAR 550.
3) Release the hooks of the COVER REAR 550, and remove the CHUTE LOW FU from the COVER
REAR 550.
4) Remove the ROLL FU (PL10.2.14). (RRP10.10)
5) Remove the LEVER GATE HOLDER (PL10.2.15), SPRING LEVER GATE (PL10.2.16), LEVER
GATE FU (PL10.2.17).(RRP10.11)
6) Rotate LEVER LATCH LEFT (PL10.2.8) in the direction of the arrow, and remove it.
Fit the position of the internal projection of LEVER LATCH LEFT (PL10.2.8) and the
notch of CHUTE LOW FU (PL10.2.7) completely.
7) Rotate LEVER LATCH RIGHT (PL10.2.11) in the direction of the arrow, and remove it.
Fit the position of the internal projection of LEVER LATCH RIGHT (PL10.2.11) and
the notch of CHUTE LOW FU (PL10.2.7) completely.
PIPE LATCH FU (PL10.2.9) is also removed.
8) Remove the SPRING LATCH (PL10.2.10).
Replacement
1) Install the SPRING LATCH (PL10.2.10).
2) Install the LEVER LATCH LEFT (PL10.2.8) to PIPE LATCH FU (PL10.2.9), then install them to
CHUTE LOW FU (PL10.2.7).
3) Install the LEVER LATCH RIGHT (PL10.2.11) to PIPE LATCH FU (PL10.2.9).
4) Fit the projections of both LEVER LATCH RIGHT (PL10.2.11) and LEVER LATCH LEFT
(PL10.2.8) to the notch of CHUTE LOW FU (PL10.2.7), and install by rotating in the opposite direc-
tion of the arrow.
5) Install LEVER GATE HOLDER (PL10.2.15), SPRING LEVER GATE (PL10.2.16), and LEVER
GATE FU (PL10.2.17).
6) Install the ROLL FU (PL10.2.14).(RRP10.10).
7) Install the CHUTE LOW FU to the COVER REAR 550, and secure it with the hook.
8) Secure the CHUTE LOW FU to the COVER REAR 550 using the 5 screws (gold tapping, 6mm).
9) Install the COVER REAR 500 (PL10.2.21). (RRP10.9)