3 – 324
Chapter 3 Removal and Replacement Procedures (RRPs)
Removal
1) Remove the COVER REAR 500/COVER REAR 250 (PL10.2.21/9.1.12). (RRP10.9/9.4)
2) Remove the COVER REAR (PL1.1.3). (RRP1.1)
3) Remove the COVER LEFT (PL1.1.6). (RRP1.3)
4) Remove the COVER RIGHT (PL1.1.4). (RRP1.2)
5) Remove the COVER EXIT 500 (PL10.1.1)/CHUTE ASSY EXIT 250 (Reference Only). (PL9.1.14)
(RRP10.1/9.7)
6) Remove the 500 EXIT ASSY (PL10.1.2)/CHUTE LW EXT2 ASSY (PL9.1.2). (RRP10.2/9.1)
7) Remove the COVER TOP (PL1.1.7). (RRP1.4)
8) Remove the COVER FRONT (PL1.1.5). (RRP1.5)
9) Remove the 5 screws (silver, 6mm) securing the SHIELD PLATE LVPS to the frame.
10) Remove the SHIELD PLATE LVPS.
Replacement
1) Install the SHIELD PLATE LVPS to the frame using the 5 screws (silver, 6mm).
2) Install the COVER FRONT (PL1.1.5). (RRP1.5)
3) Install the COVER TOP (PL1.1.7). (RRP1.4)
4) Install the 500 EXIT ASSY (PL10.1.2)/CHUTE LW EXIT ASST (PL9.1.2). (RRP10.2/9.1)
When installing, pull the CHUTE EXIT FUSER lever.
5) Install the COVER EXIT 500 (PL10.1.1)/CHUTE ASSY EXIT 250 (Reference Only). (PL9.1.14)
(RRP10.1/9.7)
6) Install the COVER RIGHT (PL1.1.4). (RRP1.2)
7) Install the COVER LEFT (PL1.1.6). (RRP1.3)
8) Install the COVER REAR (PL1.1.3). (RRP1.1)
There are 2 kinds of screws, make sure they are put in the right place.
9) Install the COVER REAR 500/COVER REAR 250 (PL10.2.21/9.1.12). (RRP10.9/9.4)
To Next Page
Loading...
