3 – 344
Chapter 3 Removal and Replacement Procedures (RRPs)
Removal
1) Remove the COVER REAR 500/COVER REAR 250 (PL10.2.21/9.1.12). (RRP10.9/9.4)
2) Remove the COVER REAR (PL1.1.3). (RRP1.1)
3) Disconnect the connector (P/J244) of the FAN MAIN from the HARNESS ASSY TRAY1
(PL5.1.37).
4) Remove the 2 screws (silver tapping, 30mm) securing the FAM MAIN to the frame, and remove the
FAN MAIN.
Replacement
1) Install the FAN MAIN to the frame using the 2 screws (silver tapping, 30mm) .
When installing, be sure to install the FAN MAIN so that the label is facing outside.
When installing, make sure the harness have not pinched between the FAN MAIN
and the frame.
2) Connect the connector (P/J244) of the FAN MAIN to the HARNESS ASSY TRAY1 (PL5.1.37).
3) Install the COVER REAR (PL1.1.3). (RRP1.1)
There are 2 kinds of screws, make sure they are put in the right place.
4) Install the COVER REAR 500/COVER REAR 250 (PL10.2.21/9.1.12). (RRP10.9/9.4)
To Next Page
Loading...
