Oki Data CONFIDENTIAL
45487001TH Rev.1
4-31 /
4. Maintenance menus
4.3.2.7 Print counter display
The print counter display is used for viewing print counter values.
1. Enter the self-diagnostic mode and, until PRINTER STATUS appears, press the
MENU
or MENU button (the MENU button displays the next test option and
the MENU
button displays the preceding test option). Then press the ENTER
button.
2. Pressing the MENU
or MENU
button displays each count printed (pressing
the ONLINE or CANCEL button is disabled).
3. Press the BACK button to end the option (the state in step 1 is restored).
Upper Display Lower Display Format Unit Function
K-TOTAL
DRUM CNT
******** IMAGES DEC Images Displays the total number of
rotation.
TOTAL SHEET
CNT
******** PRINTS DEC Prints Displays the total number of
images printed.(*1)
*1 Tow counts apply to duplex print.
4.3.2.8 Factory-Shipping mode switching
The Factory-Shipping mode switching is used for switching from the Factory to Shipping
mode.
1. Enter the self-diagnostic mode and, until the following message appears, press
the MENU
or MENU button.
FACTORY MODE SET
2. Press the ENTER button. The following message appears. Press the MENU
or
MENU
button until the option to set (refer to the table shown below) appears
FACTORY MODE
SHIPPING MODE *
3. A setting for the option can be selected by pressing the ENTER button with the
option on the display.
4. Hold down the ENTER button (for three seconds) with the setting on the display.
The setting is stored in the EEPROM. The state in step 2 is restored.
5. Repeat steps 2 through 4 when necessary.
6. Press the BACK button to end the option (the state in step 1 is restored).
Option Settings Function
FACTORY
MODE
FACTORY MODE Establishes the Factory mode (a fuse-cut
disabling mode).
SHIPPING MODE Deselects the Factory mode to enable the fuse-
cut function.
FUSE INTACT
Note:
****** is either
INTACT or
BLOWN.
FUSE UNIT XXXXXX Displays the fuse status of the fuser.
To Next Page
Loading...
Need help?
General
