Oki Data CONFIDENTIAL
45487001TH Rev.1
4-34 /
4. Maintenance menus
4.3.3 Printing on stand-alone basis
B721/B731/ES7131/MPS5501b can perform the following printing on a stand-alone-basis.
Configuration Prints information, including printer menu settings, program
versions and control block configuration.
Network Prints network-related information, including a MAC address and
IP address.
Demo Page Prints demo pages.
File List Prints a list of files stored in a file system.
PostScript Font List Prints a PostScript fonts list.
PCL Font List Prints a PCL emulation fonts list.
IBM PPR Font List Prints a IBM PPR fonts list.
EPSON FX Font
List
Prints a EPSON FX fonts list.
Print statistic results Prints a statistic usage result.
* The result is displayed when Print Statistics Menu-User Report
is set to Enable.
Error Log Prints an error log.
Printing Procedure:
Verify that the message stating the printer is ready to print is showing on the
operator panel, and press the MENU
button to display FUNCTION
Press the MENU button to select the option to print printer information. Press the
ENTER button.
Press the MENU button to select the item to print. Press the ENTER button.
Press the ENTER button to print the item (the button must be pressed twice to print
a demo page).
4.3.2.12 BUZZER TEST
The BUZZER TEST function is used for the buzzer test.
1. Enter the self-diagnostic mode (Level 1) and, until the following message
appears, press the MENU
or MENU button.
BUZZER TEST
2. Pressing the ENTER button displays the following message.
Hold down the MENU
or MENU button until the target option is displayed.
BUZZER TEST
SMALL VOLUME
3. By pressing the ENTER button, the buzzer test starts and the lower display
starts to blink.
* Usually, it stops in 1 second after pressing the Enter button.
* The status is returned to Step 2 after the buzzer for one second, and the buzzer
starts again by pressing the ENTER button again.
4. Pressing the CANCEL button stops the buzzer.
5. Repeat steps 2 through 4 when necessary.
6. Press the BACK button to end the buzzer test (the state in step 1 is restored).
BUSSER TEST
Display Function
SMALL VOLUME Buzzer volume is small.
LARGE VOLUME Buzzer volume is large.
To Next Page
Loading...
Need help?
General
