Oki B721 Maintenance Manual

Oki Data CONFIDENTIAL
45487001TH Rev.1
4-39 /
4. Maintenance menus
4.6 Boot Menu List
To display Boot Menu, turn on the printer while holding down the [ENTER] button.
Memo Displaying Boot Menu requires entry of a password. The password defaults to
six a (aaaaaa).
Category Item Settings Function
Enter
Password
************ Enter a password to enter Boot menu.
The default value is "aaaaaa"
From 6 to 12 digits of numbers or Roman
character to input.
HDD
Setup
Enable
HDD
No
Ye s
Even if a machine is inoperable at installation
because an HDD has been damaged, you can
make the machine operable by setting to No to
deal with that no HDD is attached regardless of
existence of an HDD. While No is set, access
to an HDD results in FAIL because the HDD
is regarded as not attached even if the HDD is
normal.
After the setting change and exit from the menu,
the printer restarts.
[Conditions for display]
HDD implementation
Category Item Settings Function
Storage
Common
Setup
Check File
System
Execute Resolves mismatch between actual memory and
displayed memory available in a file system and
performs administration data (FAT information)
recovery. Performs these by file system. Its takes
several tens of seconds to complete the job of
this function. HDD: Performs recovery only for
an HDD.
The following message appears after pressing
the Enter switch.
Are You Sure?
Ye s
No
If No is selected, the display will be back to the
former menu. If Yes is selected, this function
initiates.
[Condition for display]
HDD insertion("Yes" is selected in "Boot Menu"-
"HDD Setup"-"Enable HDD.")
Check All
Sectors
Execute Performs recovery of a defective HDD sector
information and a file system mismatch
mentioned above. The objective device is
only an HDD and it takes 30 to 40 minutes to
completed this function for an HDD of 10GB.
The following message appears after pressing
the Enter switch.
Are You Sure?
Ye s
No
If No is selected, the display will be back to the
former menu. If Yes is selected, this function
initiates.
[Condition for display]
HDD insertion("Yes" is selected in "Boot Menu"-
"HDD Setup"-"Enable HDD.")

Oki B721 Specifications

General

Print Technology	LED
Resolution	1200 x 1200 dpi
Processor	533 MHz
Memory	256 MB
Connectivity	USB, Ethernet
Duplex Printing	Standard