Print Media4-6
Envelope
Print on the front (address) side only. Some parts of the envelope consist of
three layers of paper—the front, back, and flap. Anything printed in these lay-
ered regions may be lost or faded.
You can print continuously with envelope. However, this could affect the
media feed, depending on the media quality and printing environment. If
problems occur, stop the continuous printing and print one sheet at a time.
Use envelopes that are
îš„ Common office envelopes approved for laser printing with diagonal joints,
sharp folds and edges, and ordinary gummed flaps
" Because the envelopes pass through heated rollers, the gummed
area on the flaps may seal. Using envelopes with emulsion-based
glue avoids this problem.
îš„ Approved for laser printing
îš„ Dry
DO NOT use envelopes that have
îš„ Sticky flaps
îš„ Tape seals, metal clasps, paper clips, fasteners, or peel-off strips for seal-
ing
îš„ Transparent windows
îš„ Too rough of a surface
îš„ Material that will melt, vaporize, offset, discolor, or emit dangerous fumes
îš„ Been presealed
Capacity Tray 1 Up to 10 sheets, depending on their thick-
ness
Tray 2/3/4 Not supported
Orientation Face down
Driver
Media Type
Envelope
Duplexing Not supported
To Next Page
Loading...
Need help?
General
