Olivetti d-COLORMF3000 - Duplex Printing Configuration

About Duplex Printing4-30
About Duplex Printing
Duplex (double-sided) printing can be done with this printer, which has the
duplex unit built in as a standard. If the paper has low opacity (high translu-
cency), then the printed data from one side of the page will show through to
the other side. Check your application for margin information. For best
results, print a small quantity to make sure the opacity is acceptable.
Note
Only plain paper, special paper and thick stock, 60–210 g/m
2
can be
autoduplexed. See “Specifications” on page 4-2.
Duplexing envelopes, labels, letterheads, postcards, glossy media or
single side only papers is not supported.
How do I autoduplex?
Check your application to determine how to set your margins for duplex
(double-sided) printing.
The following Binding Position settings are available.
If [Long Edge (Left)] is selected, the pages will be laid out to
flip at the left.
If [Long Edge (Right)] is selected, the pages will be laid out
to flip at the right.
If [Short Edge (Top)] is selected, the pages will be laid out
to flip at the top.
1
1
1
1
2
3
1
1
1
1
2
3
1
3
1
2
1