Registering a user15-4
2 Install IC Card Driver (USB-Driver).
Connect the authentication device to the USB port of your computer.
The [Found New Hardware] dialog box appears.
3 Select [Locate and install driver software (recommended)].
4 Insert the application CD-ROM provided with the authentication device
into the CD-ROM drive of the computer.
5 Click the [Browse my computer for driver software (advanced)].
6 Check that the driver's search location is the application CD-ROM, and
then click [Next].
– When the driver's search location is not the application CD-ROM, click
[Browse]. Select the IC Card Driver (USB-Driver) folder in the
CD-ROM, and click [OK].
– Installation starts.
7 Click [Close].
Installation of the IC Card Driver (USB-Driver) is completed.
8 Install Data Administrator IC Card Plugin.
Open the IC_Card_Plugin folder on the application CD-ROM, and then
click setup.exe.
9 Select a language, and then click [OK].
The installation program starts.
10 Follow the on-screen instructions to proceed with the installation.
11 Click [Next].
12 Select [I accept the terms in the license agreement], and then click [Next].
13 Click [Install].
14 Click [Finish].
Installation of the Data Administrator IC Card Plugin is completed, which
completes the setup.
User registration
To register a user with Data Administrator, the computer and this machine
must be connected via network.
Also, to proceed to register a card with Data Administrator, the authentication
device must be connected to the USB port of the computer.
When registering a user, you can only enter the card ID and associate the
user with card using the authentication device unit connected to this machine.
1 Turn the main power switch on.
To Next Page
Loading...
