Registering a user 15-3
– If the card function setting page appears, specify the necessary set-
tings.
6 Exit Web Connection.
Then, proceed with the user registration.
Registering a user
Register a user using Data Administrator. The following two methods can be
used.
îš„ Connect the authentication device to your computer, and use Data Admin-
istrator to register the target user and card at a time.
îš„ Connect the authentication device to this machine, and associate the
user, who has been registered using Data Administrator, with an IC card.
Registering a user using Data Administrator
To use Data Administrator, configure this machine, and set up Data Adminis-
trator. For setup, install the IC Card Driver (USB-Driver) of the authentication
device, and then install Data Administrator IC Card Plugin.
" Before setup, install Data Administrator V4.0 or later in your computer.
For the Data Administrator operating environment and installation pro-
cedure, refer to the Data Administrator User's Guide.
Checking the version of the installed Data Administrator
1 From the [Help] menu of Data Administrator, select [Version Information].
" This software cannot be used if the version is "3.x". Install "4.x".
If Data Administrator V3.x is installed, it is removed when V4.x is
installed.
2 Click [Plug-in version].
3 In [Plug-in information list], confirm the plugin version of Data Administra-
tor.
– This software is available if the plugin version is "4.x".
Setup
1 Turn the Main Power Switch of this machine off, and disconnect the
authentication device from this machine.
To Next Page
Loading...
Need help?
General
