Registering destinations 10-37
Program destinations can be registered from the control panel of this
machine or from Web Connection. The following procedure describes how to
register from the control panel of this machine.
" For details on registering from Web Connection, refer to the [Refer-
ence Guide].
" For details on specifying a program destination to send scan data,
refer to “Selecting a program destination” on page 10-32.
1 Press [Scan to E-mail] or [Scan to Folder] to display the initial Scan to
E-mail or Scan to Folder mode screen.
2 Specify settings for the various parameters available from the [Settings]
screen.
– For details on the parameters available from the Settings screen, refer
to “Performing Scan to E-mail mode operations” on page 10-3 and
“Performing Scan to Folder mode operations” on page 10-17.
3 In the control panel, press the [Mode Memory] key.
The list of program destinations appears.
4 Press [Register].
5 Specify settings for [Name] and [Dest.] for the program destination, and
then press [OK].
– Press to display the address book screen. Select a registered
destination.
6 Press [OK].
To Next Page
Loading...
