107
Chapter 6
Measurement procedures
The optical adapter must be set in advance to do measurements. With a live
image or a recorded image displayed, press the [MEAS/ENTER] joystick on the
remote control. This causes the measurement to be done according to the
selected optical adapter. To move the cursor during measurement, tilt the
[MEAS/ENTER] joystick in the desired direction.
NOTE
• For details about error messages that may appear during measurement, see “Messages
displayed during stereo measurement” (page 147).
• To do stereo measurement it is necessary to do the settings for the stereo optical adapter
that is attached. See "Changing the selection of the optical adapter" (page 89) for details
about operations.
[MEAS/ENTER] joystick
To Next Page
Loading...
