Omni 7000 Series - Configure the OMNI 4000;7000; General Setup

OMNI 4000/7000 Installation Guide – Rev H
4-54
Configuration
4.10 Configure the OMNI 4000/7000
4.10.1 General Setup
To configure the basic setup information and options, follow these instructions:
1.
Click the Configure button in the Home
ribbon to open the Configure tree in the
left panel.
2.
Click the General Setup item in the tree
in the left panel to display its
configuration settings in the screens on
the right.
This section of the
OMNICONNECT software
provides screens for entering a
variety of information, such as the
OMNI 4000/7000 ID and location
and decimal resolution for
totalizers and correction factors
on batch and prove reports.