Omron CJ - 08-2008 - Page 603

555
Specifications of Basic I/O Units Appendix A
CJ1W-MD233 DC Input/Transistor Output Unit
(MIL Connector, 16 Inputs/16 Outputs, Sinking)
Note The ON response time will be 20 µs maximum and OFF response time will be 400 µs maximum even if
the response times are set to 0 ms due to internal element delays.
Circuit Configuration
Output section (CN1) Input section (CN2)
Rated Voltage 12 to 24 V DC Rated Input Voltage 24 V DC
Operating Input Volt-
age
20.4 to 26.4 V DC
Operating Load Volt-
age Range
10.2 to 26.4 V DC Input Impedance 3.3 kΩ
Maximum Load Cur-
rent
0.5 A/point, 2.0 A/Unit Input Current 7 mA typical (at 24 V DC)
Maximum Inrush Cur-
rent
4.0 A/point, 10 ms max. ON Voltage/ON Cur-
rent
14.4 V DC min./3 mA min.
Leakage Current 0.1 mA max. OFF Voltage/OFF
Current
5 V DC max./1 mA max.
Residual Voltage 1.5 V max. ON Response Time 8.0 ms max. (Can be set to between
0 and 32 in the PLC Setup.) (See
note.)
ON Response Time 0.1 ms max.
OFF Response Time 0.8 ms max. OFF Response Time 8.0 ms max. (Can be set to between
0 and 32 in the PLC Setup.) (See
note.)
No. of Circuits 16 (16 points/common, 1 circuit)
Fuse None No. of Circuits 16 (16 points/common, 1 circuit)
External Power Sup-
ply
12 to 24 V DC, 20 mA min. Number of Simulta-
neously ON Points
75% (at 24 V DC)
Insulation Resistance 20 MΩ between the external terminals and the GR terminal (at 100 V DC)
Dielectric Strength 1,000 V AC between the external terminals and the GR terminal for 1 minute at a leakage current
of 10 mA max.
Internal Current Con-
sumption
5 V DC 130 mA max.
Weight 90 g max.
Accessories None
IN00
COM1
IN15
COM1
3.3 kΩ
3.3 kΩ
1000 pF
470
Ω
1000 pF
470
Ω
OUT00
+V
+V
OUT15
COM0
COM0
CN2 (IN)
CN1 (OUT)
OUT08
IN08
IN07
OUT07
to
to
Input indicator
Internal circuits
Internal circuits
to
to
Output
indicator