Omron HS-360X - User Preferences Parameter Defaults

HS-360X Handheld DPM Scanner User Manual 5-3
User Preferences and Miscellaneous Options
User Preferences Parameter Defaults
The table below lists defaults for user preferences parameters. To change the default values:
• Scan the appropriate programming symbols in this guide. These new values replace th
e
stand
ard default values in memo
ry.
•
Configure the scanner using WebLink
PC
.
See Appendix A — Standard Default Parameters for all user preferences, hosts, symbologies,
and default parameters.
Parameter
Parameter
Number
1
Default
User Preferences
Set Default Parameter Restore Defaults
Parameter Barcode Scanning 236 Enable
Beep After Good Decode 56 Enable
Direct Decode Indicator 859 Disable
Beeper Volume 140 High
Beeper Tone 145 Medium
Beeper Duration 628 Medium
Suppress Power Up Beeps 721 Do Not Suppress
Decode Pager Motor 613 Enable
Decode Pager Motor Duration 626 150 msec
Low Power Mode 128
Enable (HS-360X Wireless Scanner)
Disable (HS-360X Wired Scanner)
Time Delay to Low Power Mode 146
100 ms (HS-360X Wireless Scanner)
1 Hour (HS-360X Wired Scanner)
Timeout to Low Power Mode from Auto Aim (HS-360X
Wired Only)
729 15 Seconds
Handheld Trigger Mode 138 Level
Hands-Free Mode 630 Enable
Handheld Decode Aiming Pattern 306 Enable
Hands-Free (Presentation) Decode Aiming Pattern 590
Enable Hands-Free (Presentation)
Decode Aiming Pattern on PDF
Picklist Mode 402 Disabled Always
FIPS Mode
(HS-360X Wired Scanner Only)
736 Disable
Continuous Barcode Read 649 Disable
Unique Barcode Reporting 723 Enable
Decode Session Timeout 136 9.9 Seconds
Hands-free Decode Session Timeout 400 15
1.
Parame
ter number decimal values are used for programming via RSM commands.