HS-360X Handheld DPM Scanner User Manual 8-5
RS-232 Interface
RS-232 Parameter Defaults
The table below lists the defaults for RS-232 host parameters. To change any option, scan
the appropriate programming symbol(s) provided in the RS-232 Host Parameters section.
Parameter Default
RS-232 Host Parameters
RS-232 Host Types Standard
Baud Rate 9600
Parity Type None
Stop Bits 1 Stop Bit
Data Bits 8-Bit
Check Receive Errors Enable
Hardware Handshaking None
Software Handshaking None
Host Serial Response Time-out 2 Seconds
RTS Line State Low RTS
Beep on <BEL> Disable
Intercharacter Delay 0 msec
Nixdorf Beep/LED Options Normal Operation
Ignore Unknown Characters Send Barcode
To Next Page
Loading...
