HS-360X Handheld DPM Scanner User Manual 5-45
User Preferences and Miscellaneous Options
FN1 Substitution Values
Key Category Parameter # 103
Decimal Value Parameter # 109
The wedge and USB HID keyboard hosts support a FN1 Substitution feature. Enabling
this substitutes any FN1 character (0x1b) in an EAN128 barcode with a value. This value
defaults to 7013 (Enter Key).
When using host commands to set the FN1 substitution value, set the key category
parameter to 1, then set the 3-digit keystroke value. See the ASCII Character Set table for
the current host interface for the desired value.
To select a FN1 substitution value via programming symbol menus:
1. Scan the programming symbol below.
2. Locate the keystroke desired for FN1 Substitution in the ASCII Character Set table
for the current host interface. Enter the 4-digit ASCII Value by scanning each digit in
Appendix H — Numeric Keyboard.
To correct an error or change the selection, scan Cancel.
To enable FN1 substitution for USB HID keyboard, scan the Enable FN1 Substitution
programming symbol.
Set FN1 Substitution Value
To Next Page
Loading...
