4-2 HS-360X Handheld DPM Scanner User Manual
HS-360X Wireless Scanner Radio Communications
HS-360X Wireless Scanner Radio Communications
The scanner ships with the settings shown in the Radio Communications Parameter
Defaults. If the default values suit requirements, programming is not necessary.
To set feature values, scan a single programming symbol or a short sequence of programming
symbols. The settings are stored in non-volatile memory and are preserved even when the
scanner is powered down.
If not using a USB cable with the cradle, select a host type (see each host chapter for specific
host information) after the power-up beep. This is only necessary upon the first power-up
when connected to a new host.
Scanning Sequence Examples
In most cases, scan one programming symbol to set a specific parameter value.
Errors While Scanning
Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the
correct parameter.
To Next Page
Loading...
