9-2 HS-360X Handheld DPM Scanner User Manual
Introduction
Introduction
Most computer monitors allow scanning the programming symbols directly on the screen.
When scanning from the screen, be sure to set the document magnification to a level
where you can see the programming symbol clearly, and bars and/or spaces do not
merge.
Select a host type (see each host chapter for specific host information) after the power-up
beeps sound. This is only necessary upon the first power-up when connected to a new host.
Scanning Sequence Examples
In most cases, scanning one programming symbol sets the parameter value. For example,
to transmit barcode data without the UPC-A check digit, simply scan the Do Not Transmit
UPC-A Check Digit programming symbol under Transmit UPC-A Check Digit. The
scanner issues a fast warble beep and the LED turns green, signifying a successful
parameter entry.
Other parameters, such as
Set Length(s) for D 2 of 5
require scanning several programming
symbols. See the individual parameter, such as
Set Length(s) for D 2 of 5
, for this procedure.
Errors While Scanning
Unless otherwise specified, to correct an error during a scanning sequence, just re-scan
the correct parameter.
To Next Page
Loading...
