Omron HS-360X - Beep on <BEL

4-36 HS-360X Handheld DPM Scanner User Manual
Beep on <BEL>
Beep on <BEL>
Parameter # 150
When this parameter is enabled, the scanner issues a beep when a <BEL> character is
detected on the serial line. <BEL> is issued to gain a user's attention to an illegal entry or
other important events.
This parameter only applies to SPP (Serial Port Profile). The RS-232 interface on the cradle
has this feature when Beep on <BEL> is enabled.
In Multipoint-to-Point mode only, the scanner that beeped last sounds Beep on <BEL>.
* Beep on <BEL> Enable
(1)
Beep on <BEL> Disable
(0)