Omron HS-360X - Scanner(S)-To-Cradle Support

HS-360X Handheld DPM Scanner User Manual 4-37
Radio Communications
Scanner(s)-to-Cradle Support
Modes of Operation
Parameter # 538
The charging cradle with radio supports two radio communication modes of operation, allowing
the scanner to communicate wirelessly:
• Point-to-Point
• Multipoint-to-Point
Point-to-Point Communication
In Point-to-Point communication mode, the cradle allows one scanner to connect to it at a
time. In this mode, the scanner is paired to the cradle either by insertion into the cradle or by
scanning the PAIR symbol. Communication can be locked, unlocked (default), or in a lock
override state. In locked mode, locking intervals must be set by scanning a connection
maintenance interval programming symbol.
To activate this mode of operation, scan Point-to-Point.
Multipoint-to-Point Communication
Multipoint-to-Point communication mode allows up to seven scanners to pair to one cradle.
To activate this mode, the first scanner connected to the cradle must scan the Multipoint-to-Point
programming symbol. This mode allows a parameter broadcast feature that forwards
parameter programming symbol settings to all connected scanners. In this mode, programming
one scanner applies the settings to all connected scanners.
To select Point-to-Point or Multipoint-to-Point mode, scan the appropriate programming symbol.
Multipoint-to-Point Mode
(1)
* Point-to-Point Mode
(0)