Omron HS-360X - Symbology Parameter Defaults

HS-360X Handheld DPM Scanner User Manual 9-3
Symbologies
Symbology Parameter Defaults
The table below lists the defaults for all symbology parameters. To change the default
values, scan the appropriate programming symbols in this guide. These new values
replace the standard default values in memory.
Parameter
Parameter
Number
Default
Enable/Disable All Code Types
1D Symbologies
UPC/EAN
UPC-A 1 Enable
UPC-E 2 Enable
UPC-E1 12 Disable
EAN-8/JAN 8 4 Enable
EAN-13/JAN 13 3 Enable
Bookland EAN 83 Disable
Decode UPC/EAN/JAN Supplementals
(2 and 5 digits)
16 Ignore
User-Programmable Supplementals
Supplemental 1:
Supplemental 2:
579
580
000
UPC/EAN/JAN Supplemental Redundancy 80 10
Decode UPC/EAN/JAN Supplemental
AIM ID
672 Combined
UPC Reduced Quiet Zone 1289 Disable
Transmit UPC-A Check Digit 40 Enable
Transmit UPC-E Check Digit 41 Enable
Transmit UPC-E1 Check Digit 42 Enable
UPC-A Preamble 34 System Character
UPC-E Preamble 35 System Character
UPC-E1 Preamble 36 System Character
Convert UPC-E to A 37 Disable
Convert UPC-E1 to A 38 Disable
EAN-8/JAN-8 Extend 39 Disable
Bookland ISBN Format 576 ISBN-10
UCC Coupon Extended Code 85 Disable
Coupon Report 730 New Coupon Format
ISSN EAN 617 Disable
Code 128
Code 128 8 Enable