1-10 HS-360X Handheld DPM Scanner User Manual
HS-360X Wireless Handheld DPM Scanner
Sending Data to the Host Computer
The cradle receives data from the scanner via a wireless radio connection and transmits it to
the host computer via the host cable. The scanner and cradle must be paired for successful
wireless communication.
Pairing
Pairing registers a scanner to the cradle such that the scanner and cradle can exchange
information. The cradle operates in two modes: Point-to-Point and Multipoint-to-Point. In
Point-to-Point mode, pair the scanner to the cradle either by inserting it in the cradle (if pair
on contacts is enabled), or by scanning the pairing symbol. In Multipoint-to-Point mode, you
can pair up to seven scanners to one cradle.
To pair the scanner with the cradle, scan a pairing symbol. A high-low-high-low beep sequence
followed by a low-high beep sequence indicates successful pairing and connection to the
remote device. A long low, long high beep sequence indicates unsuccessful pairing.
The pairing symbol that connects the scanner to a cradle is unique to each cradle.
Do not scan data or parameters until pairing completes.
Lost Connection to Host
If scanned data does not transmit to the cradle's host, ensure that all cables are firmly
inserted and the power supply is connected to an appropriate AC outlet, if applicable. If
scanned data still does not transmit to the host, reestablish a connection with the host:
1. Disconnect the power supply from the cradle.
2. Disconnect the host interface cable from the cradle.
3. Wait three seconds.
4. Reconnect the host interface cable to the cradle.
5. Reconnect the power supply to the cradle, if the host requires.
6. Reestablish pairing with the cradle by scanning the pairing symbol.
Configuring the Scanner
Use the configuration symbols in this manual or the WebLink
PC
configuration program to
configure the scanner.
Radio Communications
The scanner can communicate with remote devices via Bluetooth, or by pairing with a cradle.
To Next Page
Loading...
