HS-360X Handheld DPM Scanner User Manual 2-7
Data Capture
HS-360X Beeper and LED Definitions
In addition to beep sequences, the scanner uses a two-color LED to indicate status.
Event Beeper Sequence LED Indicator
Standard Use
Power up. Low, Medium, High beeps Green
Decode a barcode.
(as configured) Green
Hands-free Mode
(Presentation Mode On).
None Green (stays on)
Handheld Mode
(Presentation Mode Off).
None Green (stays off)
Transmission error.
4 Low beeps Red
Conversion or format error.
5 Low beeps Red
RS-232 receive error (Parity Error).
Low, Low, Low, Extra-Low beeps Red
A <BEL> character is received
over RS-232.
High beep None
Parameter Programming
Input error: Incorrect barcode,
programming sequence, or Cancel
scanned.
Low, High beeps Red
Number expected. Enter value
using numeric barcodes.
High, Low beeps Green
Successful program exit with
change in parameter setting.
High, Low, High, Low beeps Green
Maintenance Indications
Enter Bootloader High, High beeps Red (stays on)
Firmware Installation None Red Blinking
To Next Page
Loading...
