1-8 HS-360X Handheld DPM Scanner User Manual
HS-360X Wireless Handheld DPM Scanner
Inserting the Wireless HS-360X Battery
A PowerPrecision+ 3100 mAh Li-Ion rechargeable battery ships with each wireless HS-360X.
Batteries are shipped in an Off mode and do not power the scanner. After inserting a new
battery into the HS-360X scanner, you must insert the scanner into a cradle for the battery to
turn On.
Alternatively, the battery can be placed in the four slot spare battery charger to charge and
then inserted in the scanner for immediate use.
The battery resides in a chamber in the scanner handle. To insert the battery:
1. Lightly press down and slide the locking lever counterclockwise to unlock and
release the battery door.
2. Open the battery door.
3. If a battery is already installed, turn the scanner upright to slide the battery out.
4. Slide the new battery into the chamber, with the rounded side toward the back and
the contacts facing into the chamber.
1. Close the battery door.
2. Lightly press down and slide the locking lever clockwise to lock the battery door.
3. If using a brand new battery, insert the scanner into a cradle to turn the battery on.
Removing the HS-360X Battery
To remove the battery:
1. Lightly press down and slide the locking lever counterclockwise to unlock the battery door.
2. Open the battery door.
3. Turn the scanner upright to slide the battery out.
Unlock
Lock
Inserting the Battery
To Next Page
Loading...
