7-26 MicroHAWK Engine Integration Guide
UPC/EAN
Supplemental Type (UPC/EAN)
Both
Either 2 character or 5 character supplementals will be considered valid.
2 Characters Only
Only two character supplementals will be considered valid.
5 Characters Only
Only five character supplementals will be considered valid.
Format UPC-E as UPC-A (UPC/EAN)
Usage: As required by symbology used in application.
Definition: Allows the user to select 2 character or 5 character supplements, or both.
Serial Cmd: <K473,UPC status,EAN status,supplementals status,separator status,
separator character,supplemental type,format UPC-E as UPC-A>
Default: Both
Options: 0 = Both 1 = 2 characters only 2 = 5 characters only
Definition: When disabled, the reader will output the version E symbols in their
encoded 6-character format.
When enabled, the reader will format the symbol as either a 12-character
UPC-A symbol or an EAN-13 symbol, depending on the state of the EAN
status parameter. This formatting reverses the zero suppression that is
used to generate the symbol in the UPC specification.
Serial Cmd: <K473,UPC status,EAN status,supplementals status,separator status,
separator character,supplemental type,format UPC-E as UPC-A>
Default: Disabled
Options: 0 = Disabled 1 = Enabled
To Next Page
Loading...
