Omron MicroHAWK - Time Since Reset

MicroHAWK Engine Integration Guide 8-33
I/O Parameters
Time Since Reset
Note: Time Since Reset is a read-only command.
Hours
Hours uses a 16-bit counter that increments every 60 minutes.
Minutes
Minutes uses a 16-bit counter that increments every 60 seconds.
Note: Time counts are reset at power-on, but not with an <A> or <Z> command.
Serial Cmd: <K407,hours,minutes>
Default: 16-bit counter (0 to 65535)
Serial Cmd: <K407,hours,minutes>
Default: 16-bit counter (0 to 60)