Omron MicroHAWK - Default Chapter; Table of Contents

MicroHAWK Engine Integration Guide iii
Introduction
Table of Contents
Chapter 1 Quick Start
MicroHAWK Engine and WebLink Quick Start ........................................ 1-2
Step 1 Check Hardware and Connect the System .................................. 1-2
Step 2 Mount and Position the Reader.................................................... 1-3
Step 3 Install WebLink Drivers (ID-20 and ID-30) ................................... 1-4
Step 4 Connect to WebLink..................................................................... 1-5
Step 5 Explore the Start View.................................................................. 1-6
Step 6 Create a New Setup or Load an Existing Setup........................... 1-7
Step 7 Explore the Setup View................................................................ 1-8
Step 8 Configure Read Cycle Settings .................................................... 1-9
Step 9 Configure Acquire Settings ........................................................1-11
Step 10 Configure Symbology Settings.................................................1-13
Step 11 Format Output and Configure Match String ............................. 1-14
Step 12 Configure Output 1, 2, and 3 Settings...................................... 1-15
Step 13 Run the Application .................................................................. 1-16
MicroHAWK Engine and ESP Software Quick Start.............................. 1-17
Step 1 Check Hardware and Connect the System ................................ 1-17
Step 2 Mount and Position the Reader.................................................. 1-18
Step 3 Install ESP.................................................................................. 1-19
Step 4 Select Model .............................................................................. 1-20
Step 5 Connect......................................................................................1-21
Step 6 Locate the Symbol in the Field of View ...................................... 1-22
Step 7 Calibrate..................................................................................... 1-23
Step 8 Test Read Rate .......................................................................... 1-24
Step 9 Configure the Reader in ESP..................................................... 1-25
Step 10 Save Configuration in ESP....................................................... 1-26
MicroHAWK Engine and AutoVISION Quick Start ................................1-27
AutoVISION Overview ........................................................................... 1-28
Select a Device...................................................................................... 1-39
Adjust Camera Settings......................................................................... 1-40
Edit the Job............................................................................................ 1-42
Run the Job ........................................................................................... 1-43
Save the Job.......................................................................................... 1-44
Additional Notes: CPU Idle States (C-States) ....................................... 1-45
MicroHAWK Part Number Structure ...................................................... 1-46
Chapter 2 Using ESP
EZ Mode ..................................................................................................2-2
Application Mode ..................................................................................... 2-3
Menu Toolbar .......................................................................................... 2-4
View...................................................................................................... 2-13
Navigating in ESP................................................................................. 2-14
Send/Receive Options.......................................................................... 2-15