Omron MicroHAWK - Matchcode Serial Commands

MicroHAWK Engine Integration Guide 10-3
Matchcode
Matchcode Serial Commands
Matchcode
<K223,matchcode type,sequential matching,match start
position,match length,wildcard character, sequence on
No-Read,sequence on mismatch>
Number of Master Symbols <K224,number of master symbols>
New Master Pin <K225,status>
Sequence Step Interval <K228,sequence step interval>
Master Symbol Data <K231,index,master symbol data>
Match Replace <K735,status,match replacement string>
Mismatch Replace <K736,status,mismatch replacement string>