5-22
n126 Frequency Reference 15 Register 017E
Hex
Changes during
operation
Yes
Setting
range
0.00 to max. frequency Unit of
setting
0.01 Hz
(see
note 1)
Default setting 0.00
n127 Frequency Reference 16 Register 017F
Hex
Changes during
operation
Yes
Setting
range
0.00 to max. frequency Unit of
setting
0.01 Hz
(see
note 1)
Default setting 0.00
Note 1. The setting unit of frequency references 1 through 16 is changed with the set
value in n035 for frequencyreferencesettingand decimal place selection.Val-
ues will be set in 0.01-Hz increments if the frequency is less than 100 Hz and
0.1-Hz increments if the frequency is 100 Hz or over.
Note 2. Frequency reference 1 is enabled with n004 for frequency reference selection
set to 1.
Note 3. Frequencyreferences2through16areenabledbysettingmulti-stepspeedref-
erences 1 through 4 in n050 through n056 for multi-function input. Refer to the
following table for the relationship between multi-step speed references 1
through 4 and frequency references 1 through 16.
Frequency reference Multi-step
speed refer-
ence 1
(Set value: 6)
Multi-step
speed refer-
ence 2
(Set value: 7)
Multi-step
speed refer-
ence 3
(Set value: 8)
Multi-step
speed refer-
ence 4
(Set value: 9)
Frequency reference 1 OFF OFF OFF OFF
Frequency reference 2 ON OFF OFF OFF
Frequency reference 3 OFF ON OFF OFF
Frequency reference 4 ON ON OFF OFF
Frequency reference 5 OFF OFF ON OFF
Frequency reference 6 ON OFF ON OFF
Frequency reference 7 OFF ON ON OFF
Frequency reference 8 ON ON ON OFF
Frequency reference 9 OFF OFF OFF ON
Frequency reference 10 ON OFF OFF ON
Frequency reference 11 OFF ON OFF ON
Frequency reference 12 ON ON OFF ON
Frequency reference 13 OFF OFF ON ON
Frequency reference 14 ON OFF ON ON
Frequency reference 15 OFF ON ON ON
Frequency reference 16 ON ON ON ON
Basic Operation Chapter 5
To Next Page
Loading...
