Omron SYSDRIVE 3G3MV - Terminal Block

2-12
2-2-1 Terminal Block
To wire the terminal block of the Inverter, remove the front cover, terminal
cover (unless the Inverter is a 200-V model), and bottom cover from the
Inverter.
There is a label under the front cover indicating the arrangement of main
circuitterminals.Besuretoremovethelabelafterwiringtheterminals.The
output terminal of the motor has a label as well. Remove the label before
wiring the motor terminal.
H Arrangement of Control Circuit Terminals
Control circuit terminals
H Arrangement of Main Circuit Terminals
D 3G3MV-A2001 through 3G3MV-A2007 (0.1 through 0.75 kW):
3-phase 200-VAC Input
3G3MV-AB001 through 3G3MV-AB004 (0.1 through 0.4 kW):
Single-phase 200-VAC Input
Power supply input Motor output
Braking resistor
Note For single-phase input, connect R/L1 and S/L2.
Design Chapter 2